1958, 216 Seiten mit zahlreichen Diagrammen und 2 Ausschlagtafeln. Gebunden Halbleinen.

Prof. Hugh Ford: Foreword - W. C. F. Hessenberg: Introduction - E. Orowan: The Calculation of Roll Pressure in Hot and Cold Flat Rolling - Hugh Ford: Researches into the Deformation of Metals by Cold Rolling - D. R. Bland & Hugh Ford: The Calculation of Roll Force and Torque in Cold Strip Rolling with Tensions - M. Cook & E. C. Larke: Calculation of loads involved in Metal Strip Rolling - R. Hill Relations between Roll-Force, Torque, and the Applied Tensions in Strip-Rolling - W. C. F. Hessenberg & R. B. Sims: The Effect of Tension on Torque and Roll Force in Cold Strip Rolling - F. Ellis, D. R. Bland & Hugh Ford: Cold Rolling with Strip Tension, Part I: A New Approximate Method of Calculation and a Comparison with other Methods - F. Ellis & Hugh Ford: Cold Rolling with Strip Tension, Part II: Comparison of Calculated and Experimental Results - D. R. Bland & Hugh Ford: Cold Rolling with Strip Tension, Part III: An Approximate Treatment of the Elastic Compression of the Strip in Cold Rolling - R. Hill & I. M. Longman: A Note on the Cold Rolling of Very Thin Strip - R. B. Sims: Calculation of Roll Force and Torque in Cold-Rolling by Graphical and Experimental Methods - G. Lianis & H. Ford: A Graphical Solution of the Cold-Rolling Problem, when Tensions are Applied to the Strip - P. W. Whitton & H. Ford: Surface Friction and Lubrication in Cold Strip Rolling - R. B. Sims: Calculation of Roll Force and Torque in Hot Rolling Mills - W. C. F. Hessenberg & R. B. Sims: Principles of Continuous Gauge Control in Sheet- and Strip-Rolling - W. C. F. Hessenberg & W. N. Jenkins: Effects of Screw and Speed-Setting Changes on Gauge Speed and Tension in Tandem Mills - G. Lianis & H. Ford: Control Equations of Multistand Cold Rolling Mills.